Siemens S223 - Fan Operation; Disabling Daemon Operation; System Threshold; CPU Load

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
88 A50010-Y3-C150-2-7619
Command Mode Description
no dns Global Deletes DNS server and domain name.
6.1.10 Fan Operation
In hiD 6615 S223/S323, it is possible to control fan operation. To control fan operation,
use the following command.
Command Mode Description
fan operation {on | off} Global Configures fan operation.
It is possible to configure to start and stop fan operation according to the system tempera-
ture. To configure this, refer the Section
6.1.12.3.
6.1.11 Disabling Daemon Operation
You can disable the daemon operation unnecessarily occupying CPU. To disable certain
daemon operation, use the following command.
Command Mode Description
halt PID Enable Disables the daemon operation.
You can display PID of daemon with the show process command.
SWITCH# show process
USER PID %CPU %MEM VSZ RSS TTY STAT START TIME COMMAND
admin 1 0.0 0.5 1448 592 ? S 15:56 0:03 init [3]
admin 2 0.0 0.0 0 0 ? S 15:56 0:00 [keventd]
admin 3 0.0 0.0 0 0 ? SN 15:56 0:00 [ksoftirqd_CPU0]
admin 4 0.0 0.0 0 0 ? S 15:56 0:00 [kswapd]
--More--
6.1.12 System Threshold
You can configure the switch with various kinds of the system threshold like CPU load,
traffic, temperature, etc. Using this threshold, the hiD 6615 S223/S323 generates syslog
messages, sends SNMP traps, or performs a related procedure.
6.1.12.1 CPU Load
To set a threshold of CPU load, use the following command.
Command Mode Description
threshold cpu <21-100> {5 | 60 |
600} [<20-100> {5 | 60 | 600}]
Sets a threshold of CPU load in the unit of percent (%).
20-100: CPU load (default: 50)
5 | 60 | 600: time Interval (second)
no threshold cpu
Global
Deletes a configured threshold of CPU load.
i