Siemens S223 - Fig. 8.5 in Case External Packets Enter under Layer 2 Environment (1); Fig. 8.6 in Case External Packets Enter under Layer 2 Environment (2)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
188 A50010-Y3-C150-2-7619
Fig. 8.5 In Case External Packets Enter under Layer 2 environment (1)
To transmit the untagged packet from uplink port to subscriber, a new VLAN should be
created including all subscriber ports and uplink ports. This makes the uplink ports to rec-
ognize all other ports.
FID helps this packet forwarding. FDB is MAC Address Table that recorded in CPU. FDB
table is made of FID (FDB Identification). Because the same FID is managed in the same
MAC table, it can recognize how to process packet forwarding. If the FID is not same, the
system cannot know the information from MAC table and floods the packets.
default br2 br3
br4 br5
Outer Network
Uplink Port
SWITCH(bridge)# show vlan
u: untagged port, t: tagged port
-----------------------------------------------------------------
| 1 2 3 4
Name( VID| FID) |123456789012345678901234567890123456789012
-----------------------------------------------------------------
default( 1| 6) |u...uuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuu
br2( 2| 6) |.u.....................u..................
br3( 3| 6) |..u....................u..................
br4( 4| 6) |...u...................u..................
br5( 5| 6) |....u..................u..................
br6( 6| 6) |uuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuu
SWITCH(bridge)#
Fig. 8.6 In Case External Packets Enter under Layer 2 environment (2)
In conclusion, to use the hiD 6615 S223/S323 as Layer 2 switch, user should add the up-
link port to all VLANs and create new VLAN including all ports. If the communication be-
tween each VLAN is needed, FID should be same.
To configure FID, use the following command.
Command Mode Description
vlan fid VLANS FID Bridge
Configures FID.
VLANS: enters VLAN name
FID: enters FID value