Siemens S223 - Queue Parameter; Displaying Qos; Admin Access Rule

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
150 A50010-Y3-C150-2-7619
To define an 802.1p priory-to-queue map for 8 queues, use the following command.
Command Mode Description
qos map <0-7> <0-3> Global
Priority to queue number mapping, priority value (0-7)
according to 802.1p:
0 = lowest: best effort (be)
1: background (bg)
2: spare (spare)
3: excellent effort (ee)
4: controlled load (cl)
5: video (video)
6: voice (voice)
7: network control (ctrl)
Queue value:
0-3: queue number
7.6.3.4 Queue Parameter
To configure a queue parameter, use the following command.
Command Mode Description
qos ibp PORTS <1-8191>
Sets a ingress back-pressure:
PORTS: port numbers
qos pktlimit PORTS <0-3> <4-
2047>
Sets a maximum packet size per queue for egress port:
PORTS: port numbers
0-3: queue number
qos seglimit PORTS <0-3> <1-
8191>
Sets a maximum segment per queue for egress port:
PORTS: port numbers
0-3: queue number
no qos ibp PORTS
no qos pktlimit PORTS <0-3>
no qos seglimit PORTS <0-3>
Global
Restroes it as a default.
7.6.3.5 Displaying QoS
To display a configuration of QoS, enter following command.
Command Mode Description
show qos Shows the configuration of QoS for all ports.
show qos PORTS Shows the configuration of QoS per each port.
show qos buffer PORTS Shows the configuration of a buffer per each port.
show qos cpu
Enable
Global
Bridge
Shows the configuration of QoS for CPU packets.
7.6.4 Admin Access Rule
For the hiD 6615 S223/S323, it is possible to block a specific service connection like tel-
net, FTP, ICMP, etc with an admin access rule function.