Siemens S223 - Displaying PIM-SM Configuration

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
316 A50010-Y3-C150-2-7619
To display the PIM Snooping configuration, use the following command.
Command Mode Description
show ip pim snooping
Shows the PIM snooping configuration such as en-
able/disable status and the enabled VLANs.
show ip pim snooping vlan
VLANS
Shows the multicast router address and DR of a speci-
fied VLAN.
show ip pim snooping groups
[A.B.C.D]
show ip pim snooping groups
port
PORTS
show ip pim snooping groups
vlan
[VLANS]
Enable
Global
Bridge
Shows the PIM snooping group, source addresses of a
specified VLAN, port or multicast group address.
A.B.C.D : Multicast group address
PORTS: Spedify the logical port number to use
VLANS: VLAN ID (ex : NAME | X | X-Y)
9.3.11 Displaying PIM-SM Configuration
To display the information of PIM-SM configuration, use the following command.
Command Mode Description
show ip pim bsr-router Shows Bootstrap router (v2).
show ip pim interface [detail] Shows PIM interface information.
show ip pim local-members
[INTERFACE]
Shows PIM local membership information.
show ip pim neighbor [detail] Shows PIM neighbor information.
show ip pim mroute [A.B.C.D] Shows PIM master router.
show ip pim nexthop Shows PIM next hops.
show ip pim rp mapping Shows PIM Rendezvous Point (RP) information.
show ip pim rp-hash A.B.C.D
Enable
Global
Bridge
Shows RP to be chosen based on group selected.
A.B.C.D: group address