UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
34 A50010-Y3-C150-2-7619
3.1.10 Router Configuration Mode
To open Router Configuration mode, use the following command. The system prompt is
changed from SWITCH(config)# to SWITCH(config-router)#.
Command Mode Description
router IP-PROTOCOL Global Opens Router Configuration mode.
Routing functionalities such as RIP, OSPF, BGP, VRRP and PIM-SM are only available for
hiD 6615 S323. (Unavailable for hiD 6615 S223)
According to routing protocol way, Router Configuration mode is divided into BGP, RIP,
and OSPF. They are used to configure each IP routing protocol.
Tab. 3.10 shows a couple of main commands of Router Configuration mode.
Command Description
distance Configures distance value to find better route.
neighbor Configures neighbor router.
network Configures network to operate each routing protocol.
redistribute Registers transmitted routing information to another router’s table.
Tab. 3.10 Main Commands of Router Configuration Mode
3.1.11 VRRP Configuration Mode
To open VRRP Configuration mode, use the following command. The system prompt is
changed from SWITCH(config)# to SWITCH(config-router)#.
Command Mode Description
router vrrp INTERFACE GROUP-
ID
Global Opens VRRP Configuration mode.
Tab. 3.11 shows a couple of main commands of Router Configuration mode.
Command Description
associate Configures associated IP address same with virtual router.
authentication Configures password of virtual router group.
preempt Activates/deactivates preempt.
track Configures VRRP track.
vip-access Configures the function of accessing associated IP address.
vr-priority Assigns priority to virtual router.
vr-timers
Configures advertisement time, which means the interval that master
router distributes its information to another virtual router.
Tab. 3.11 Main Commands of VRRP Configuration Mode
!
To Next Page
Loading...
