UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
216 A50010-Y3-C150-2-7619
To delete the edge port mode, use the following command.
Command Mode Description
no stp edge-port PORTS Bridge
Deletes port edge mode:
PORTS: select the port number.
8.3.5.9 Displaying Configuration
To display the configuration after configuring STP, RSTP, and MSTP, use the following
command.
Command Mode Description
show stp Shows the configuration of STP/RSTP/MSTP.
show stp mst
Shows the configuration when it is configured as
MSTP.
show stp mst MSTID-RANGE
Shows the configuration of specific Instance, enter the
instance number.
show stp mst MSTID-RANGE {all
| PORTS} [
detail]
Enable
Global
Bridge
Shows the configuration of the specific Instance for the
ports:
MSTID_RANGE: select the MST instance number.
all: select all ports.
PORTS: select port number.
detail: show detail information (as option).
In case STP or RSTP is configured in the SURPASS hiD 6615 S223/S323, you should
configure MSTID-RANGE as 0.
To display a configured MSTP of the switch, use the following command.
Command Mode Description
show stp mst config-id {current |
pending}
Enable
Global
Bridge
Shows the MSTP configuration identifier:
current: shows the current configuration as it is used to
run MST.
pending: shows the edited configuration.
For example, after the user configures configuration ID, if you apply it to the switch with
stp mst config-id commit command, you can check configuration ID with the show stp
mst config-id current command.
However, if the user did not use the stp mst config-id commit command in order to ap-
ply to the switch after configuration, the configuration could be checked with the show
stp mst config-id pending command.
ii
i
i
To Next Page
Loading...
