UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
128 A50010-Y3-C150-2-7619
1 sec is the minimum time which can be selected. But the minimum sampling interval
currently is 30 sec, i.e., all intervals will be round up to a multiple of 30 seconds.
7.4.1.5 Activating RMON History
To activate RMON history, use the following command.
Command Mode Description
active RMON Activates RMON history.
Before activating RMON history, check if your configuration is correct. After RMON history
is activated, you cannot change its configuration. If you need to change configuration, you
need to delete the RMON history and configure it again.
7.4.1.6 Deleting Configuration of RMON History
When you need to change a configuration of RMON history, you should delete an existing
RMON history.
To delete RMON history, use the following command.
Command Mode Description
no rmon-history <1-65535> RMON
Deletes RMON history of specified number, enter the
value for deleting.
7.4.1.7 Displaying RMON History
To display RMON history, use the following command.
Command Mode Description
show running-config rmon-
history
All Shows a configured RMON history.
Always the last values will be displayed but no more than the number of the granted
buckets.
The following is an example of displaying RMON history.
SWITCH(config-rmonhistory [5])# show running-config rmon-history
!
rmon-history 5
owner test
data-source ifindex.hdlc1
interval 60
requested-buckets 25
active
!
SWITCH(config-rmonhistory [5])#
i
i
i
To Next Page
Loading...
