Siemens S223 - Auto Log-Out; System Rebooting; Manual System Rebooting

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
48 A50010-Y3-C150-2-7619
4.1.7 Auto Log-out
For security reasons of the hiD 6615 S223/S323, if no command is entered within the
configured inactivity time, the user is automatically logged out of the system. Administra-
tor can configure the inactivity timer.
To enable auto-logout function, use the following command.
Command Mode Description
exec-timeout <1-35791> [<0-59>]
Enables auto log-out.
1-35791: time unit in minutes (by default 10 minutes)
0-59: time unit in seconds
exec-timeout 0
Global
Disables auto log-out.
To display a configuration of auto-logout function, use the following command.
Command Mode Description
show exec-timeout
Enable
Global
Shows a configuration of auto-logout function.
The following is an example of configuring auto-logout function as 60 seconds and view-
ing the configuration.
SWITCH(config)# exec-timeout 60
SWITCH(config)# show exec-timeout
Log-out time : 60 seconds
SWITCH(config)#
4.1.8 System Rebooting
4.1.8.1 Manual System Rebooting
When installing or maintaining the system, some tasks require rebooting the system by
various reasons. Then you can reboot the system with a selected system OS.
To restart the system manually, use the following command.
Command Mode Description
reload [os1 | os2] Enable Restarts the system.
If you reboot the system without saving new configuration, new configuration will be de-
leted. So, you have to save the configuration before rebooting. Not to make that mistake,
hiD 6615 S223/S323 is supported to print the following message to ask if user really
wants to reboot and save configuration.
If you want to continue to reboot, press <y> key, if you want to save new configuration,
press <n> key.
SWITCH# reload
Do you want to save the system configuration? [y/n]]