User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 129
7.4.2 RMON Alarm
There are two ways to compare with the threshold: absolute comparison and delta com-
parison.
• Absolute Comparison: Comparing sample data with the threshold at configured in-
terval, if the data is more than the threshold or less than it, alarm is occurred
• Delta Comparison: Comparing difference between current data and the latest data
with the threshold, if the data is more than the threshold or less than it, alarm is oc-
curred.
You need to open RMON Alarm Configuration mode first to configure RMON alarm.
Command Mode Description
rmon-alarm <1-65535> Global
Opens RMON Alarm Configuration mode.
1-65535: index number
The following is an example of listing available commands on RMON-alarm Configuration
mode.
SWITCH(config)# rmon-alarm 1
SWITCH(config-rmonalarm[1])# ?
RMON alarm configuration commands:
active Activate the event
do To run exec commands in config mode
exit End current mode and down to previous mode
falling-event Associate the falling threshold with an existing RMON
event
falling-threshold Define the falling threshold
help Description of the interactive help system
owner Assign the owner who define and is using the history
resources
rising-event Associate the rising threshold with an existing RMON
event
rising-threshold Define the rising threshold
sample-interval Specify the sampling interval for RMON alarm
sample-type Define the sampling type
sample-variable Define the MIB Object for sample variable
show Show running system information
startup-type Define startup alarm type (default : rising)
write Write running configuration to memory or terminal
SWITCH(config-rmonalarm[1])#
7.4.2.1 Subject of RMON Alarm
User needs to configure RMON alarm and identify subject using many kinds of data from
alarm. To identify subject of alarm, use the following command.
Command Mode Description
owner NAME RMON
Identifies subject using related data, enter the name
(max. 32 characters).
To Next Page
Loading...
