User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 109
7.1.8.1 SNMP Trap Host
To set an SNMP trap host, use the following command.
Command Mode Description
snmp trap-host
IP-ADDRESS [COMMUNITY]
snmp trap2-host
IP-ADDRESS [COMMUNITY]
Specifies IP address of an SNMP trap host.
snmp inform-trap-host
IP-ADDRESS [COMMUNITY]
Global
Specifies IP address of SNMP information trap host.
You need to configure an SNMP trap host with the snmp trap2-host command, if you
manage the switch via the ACI-E.
To delete a specified SNMP trap host, use the following command.
Command Mode Description
no snmp trap-host IP-ADDRESS
no snmp trap2-host IP-ADDRESS
Deletes a specified SNMP trap host.
no snmp inform-trap-host IP-ADDRESS
Global
Deletes a specified information trap host.
You can set maximum 16 SNMP trap hosts with inputting one by one.
The following is an example of setting an SNMP trap host.
SWITCH(config)# snmp trap-host 10.1.1.3
SWITCH(config)# snmp trap-host 20.1.1.5
SWITCH(config)# snmp trap-host 30.1.1.2
SWITCH(config)#
7.1.8.2 SNMP Trap Mode
To select an SNMP trap-mode, use the following command.
Command Mode Description
snmp trap-mode {alarm-report |
event}
Global
Selects SNMP trap-mode according to user’s network
environment. ( alarm-report or event)
• “event” trap-mode is set by default. It means that Dasan trap OID will be used upon
sending the trap if the trap-mode is “event”
• “alarm-report” trap-mode will be used form SLE MIB OID which is Siemens private
OID.
In order to manage hiD 6615 S223/S323 using ACI-E, the trap-mode must be set as
“alarm-report”. Otherwise, ACI-E would not recognize any traps set from the hiD 6615
S223/S323.
i
i
i
To Next Page
Loading...
