Siemens S223 - Configuring VRRP; Associated IP Address

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
228 A50010-Y3-C150-2-7619
8.4.1 Configuring VRRP
To configure the hiD 6615 S323 as device in Virtual Router, use the following command
on Global Configuration mode. Then you can configure VRRP by opening VRRP Configu-
ration mode.
Command Mode Description
router vrrp INTERFACE GROUP-
ID
Global
Configures Virtual Router (VRRP Group).
GROUP-ID: 1-255
To display a configuration of VRRP, use the following command.
Command Mode Description
show vrrp Shows current configuration of VRRP.
show vrrp INTERFACE
Enable
Global
Bridge
VRRP
Shows current configuration of specified interface
VRRP.
To delete the VRRP configuration, use the following command.
Command Mode Description
no router vrrp <1-255> Global
Configures Virtual Router (VRRP Group).
1-255: group ID
8.4.1.1 Associated IP Address
After configuring a virtual router, you need to assign an associated IP address to the vir-
tual router. Assign unified IP address to routers in one group.
To assign an associate IP address to routers to a virtual router or delete a configured as-
sociate IP address, use the following command.
Command Mode Description
associate A.B.C.D Assigns an associated IP address to a virtual router.
no associate [A.B.C.D]
VRRP
Deletes an assigned associated IP address from a
virtual router.