Siemens S223 - RADIUS Server; RADIUS Server for System Authentication; RADIUS Server Priority; Timeout of Authentication Request

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 51
4.2.4 RADIUS Server
4.2.4.1 RADIUS Server for System Authentication
To add/delete the RADIUS server for system authentication, use the following command.
Command Mode Description
login radius server A.B.C.D
KEY
Adds the RADIUS server with its information.
A.B.C.D: RADIUS server address
KEY: authentication key value
login radius server A.B.C.D
KEY auth_port PORT acct_port
PORT
Adds the RADIUS server with its information.
A.B.C.D: RADIUS server address
KEY: authentication key value
auth_port: Enters authentication port number(optional)
acct_port: Enters accounting port number(optional)
no login radius server A.B.C.D
Global
Deletes an added RADIUS server.
You can add up to 5 RADIUS servers.
4.2.4.2 RADIUS Server Priority
To specify the priority of a registered RADIUS server, use the following command.
Command Mode Description
login radius server move
A.B.C.D <1-5>
Global
Specifies the priority of RADIUS server.
A.B.C.D: IP address
1-5: priority of RADIUS server
4.2.4.3 Timeout of Authentication Request
After the authentication request, the hiD 6615 S223/S323 waits for the response from the
RADIUS server for specified time.
To specify a timeout value, use the following command.
Command Mode Description
login radius timeout <1-100> Global
Specifies a timeout value.
1-100: waiting-time for the response (default: 3)
i