Siemens S223 - Mstp Configuration; Fig. 8.27 Example of Layer 2 Network Design in MSTP Environment

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
226 A50010-Y3-C150-2-7619
MSTP Configuration
Router
VLAN 101 ~ 200
MST Region 1
Instance 1 VLAN 111~120
Instance 2 VLAN 121~130
Instance 3 VLAN 131~140
Region Name : test
Revision :1
MST Region 2
Instance 1 VLAN 170
Instance 2 VLAN 180~190
Instance 3 VLAN 191~195
Region Name : test
Revision :2
MST Region 3
Instance 4 VLAN 150~160
Instance 5 VLAN 161~165
Region Name : sample
Revision :5
MST Region 4
Instance 6 VLAN 200
Region Name : test
Revision :1
Fig. 8.27 Example of Layer 2 Network Design in MSTP Environment
The following is an example of configuring MSTP in the switch.
SWITCH(bridge)# stp force-version mstp
SWITCH(bridge)# stp mst enable
SWITCH(bridge)# stp mst config-id map 2 1-50
SWITCH(bridge)# stp mst config-id name 1
SWITCH(bridge)# stp mst config-id revision 1
SWITCH(bridge)# stp mst config-id commit
SWITCH(bridge)# show stp mst
Status enabled
bridge id 8000.00d0cb000183
designated root 8000.00d0cb000183
root port 0 path cost 0
max age 20.00 bridge max age 20.00
hello time 2.00 bridge hello time 2.00
forward delay 15.00 bridge forward delay 15.00
CIST regional root 8000.00d0cb000183 CIST path cost 0
max hops 20
name TEST
revision 1
instance vlans
--------------------------------------------------------------------
CIST 51-4094
2 1-50
--------------------------------------------------------------------
SWITCH(bridge)#