Siemens S223 - Initializing Authentication Status; Applying Default Value; Displaying 802.1 X Configuration; User Authentication Statistic

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
70 A50010-Y3-C150-2-7619
the following command.
Command Mode Description
dot1x reauthenticate PORTS Global
Implement re-authentication regardless of the config-
ured time interval.
4.5.3 Initializing Authentication Status
The user can initialize the entire configuration on the port. Once the port is initialized, the
supplicants accessing to the port should be re-authenticated.
Command Mode Description
dot1x initialize PORTS Global Initializes the authentication status on the port.
4.5.4 Applying Default Value
To apply the default value to the system, use the following command.
Command Mode Description
dot1x default PORTS Global Applies the default value.
4.5.5 Displaying 802.1x Configuration
To display 802.1x configuration, use the following command.
Command Mode Description
show dot1x [PORTS]
Enable
Global
Shows 802.1x configuration.
4.5.6 802.1x User Authentication Statistic
To display the statistics about the process of 802.1x user authentication, use the following
command.
Command Mode Description
show dot1x statistics PORTS Global
Shows the statistics of 802.1x user authentication on
the port.
To reset statistics by deleting the statistics of 802.1x user authentication, use the following
command.
Command Mode Description
dot1x clear statistics PORTS Global
Makes reset state by deleting the statistics of 802.1x
on the port.