UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
318 A50010-Y3-C150-2-7619
10.1.1 Basic Configuration
10.1.1.1 Configuration Type of BGP
When configuring BGP, you can select BGP configuration type between standard BGP
and ZebOS BGP for the hiD 6615 S323.
The standard BGP is one of the general BGP configuration type, which includes the fol-
lowing restrictions.
• Manual transmission of community information
You should send the community information or message to neighbors directly using
the neighbor {
A.B.C.D | WORD} send-community command.
• No synchronization
Standard configuration type does not support a synchronization between IGP and
eBGP. In this type, BGP network disables IGP synchronization in BGP by default.
• No auto-summary
Standard configuration type does not support auto summary feature. By default, the
system disables the automatic network number summarization.
The ZebOS type requires no specific configuration for sending out BGP community and
extended community attributes. ZebOS type is the default for the hiD 6615 S323.
To select configuration type of the BGP router, use the following command.
Command Mode Description
bgp config-type {standard | ze-
bos
}
Sets the BGP configuration type between standard and
ZebOS.
no bgp config-type
Global
Deletes the recent BGP configuration type and returns
to default.
10.1.1.2 Enabling BGP Routing
Step 1
To define an AS number and open
Router Configuration mode, use the following com-
mand.
Command Mode Description
router bgp <1-65535> Global
Assigns AS number to configure BGP routing and
opens Router Configuration mode.
1-65535: AS number
i
To Next Page
Loading...
