Siemens S223 - Page 122

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
122 A50010-Y3-C150-2-7619
The following is to configure to enable OAM loopback function through 25 port of the
switch and operate once.
SWITCH(bridge)# oam local admin enable 25
SWITCH(bridge)# oam remote loopback enable 25
SWITCH(bridge)# show oam local 25
LOCAL PORT[25]
-------------------------------------------
item | value
-------------------------------------------
admin | ENABLE
mode | ACTIVE
mux action | FORWARD
par action | DISCARD
variable | UNSUPPORT
link event | UNSUPPORT
loopback | SUPPORT(disable)
uni-direction | UNSUPPORT(disable)
-------------------------------------------
SWITCH(bridge)# show oam remote 25
REMOTE PORT[25]
-------------------------------------------
item | value
-------------------------------------------
mode | ACTIVE
MAC address | 00:d0:cb:27:00:94
variable | UNSUPPORT
link event | UNSUPPORT
loopback | SUPPORT(enable)
uni-direction | UNSUPPORT
-------------------------------------------
SWITCH(bridge)# oam remote loopback start 25
PORT[25]: The remote DTE loopback is success.
SWITCH(bridge)#