Siemens S223 - Page 339

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 339
Transmit delay is considering of the configuration for LSA transmission time.
The interval explained as above must be consistent across all routers in an attached net-
work.
To configure a Hello interval, use the following command.
Command Mode Description
ip ospf hello-interval <1-65535>
ip ospf A.B.C.D hello-interval <1-
65535>
Configures a Hello interval in the unit of second.
1-65535: interval value (default: 10)
no ip ospf hello-interval
no ip ospf A.B.C.D hello-interval
Interface
Sets a Hello interval to the default value.
To configure a retransmit interval, use the following command.
Command Mode Description
ip ospf retransmit-interval <1-
65535>
ip ospf A.B.C.D retransmit-
interval
<1-65535>
Configures a retransmit interval in the unit of second.
1-65535: interval value (default: 5)
no ip ospf retransmit-interval
no ip ospf A.B.C.D retransmit-
interval
Interface
Sets a retransmit interval to the default value.
To configure a dead interval, use the following command.
Command Mode Description
ip ospf dead-interval <1-65535>
ip ospf A.B.C.D dead-interval <1-
65535>
Configures a dead interval in the unit of second.
1-65535: interval value (default: 40)
no ip ospf dead-interval
no ip ospf A.B.C.D dead-interval
Interface
Sets a dead interval to the default value.
To configure a transmit delay, use the following command.
Command Mode Description
ip ospf transmit-delay <1-65535>
ip ospf A.B.C.D transmit-delay
<1-65535>
Configures a transmit delay in the unit of second.
1-65535: interval value (default: 1)
no ip ospf transmit-delay
no ip ospf A.B.C.D transmit-
delay
Interface
Sets a transmit delay to the default value.
i