UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
348 A50010-Y3-C150-2-7619
In this time, if there is no answer from receiver for configured time, the router trans-
mits LSA again. Retransmit-interval is configuration of the time interval between
transmission and retransmission
• Dead-interval
If there is no hello packet for the configured time. The router perceives other router is
stopped working. Dead-interval is configuration of the time interval which perceives
other router is stopped operating.
• Transmit-delay
When a router transmits LSA, the traffic can be delayed by status of communications.
Transmit-delay is considering of the configuration for LSA transmission time.
Configuration for virtual link can be selected more than 2 options without order. The fol-
lowing is explaining options of command:
• authentication [message-digest | null]
• authentication-key KEY
•
message-digest-key KEY md5 KEY
•
hello-interval <1-65535>
• retransmit-interval <1-65535>
• dead-interval <1-65535>
• transmit-delay <1-65535>
To configure a virtual link with one option, use the following command.
Command Mode Description
area <0-4294967295> virtual-link A.B.C.D au-
thentication
[message-digest | null]
area <0-4294967295> virtual-link A.B.C.D au-
thentication-key
KEY
area <0-4294967295> virtual-link A.B.C.D mes-
sage-digest-key
KEY md5 KEY
area <0-4294967295> virtual-link A.B.C.D hello-
interval
<1-65535>
area <0-4294967295> virtual-link A.B.C.D re-
transmit-interval
<1-65535>
area <0-4294967295> virtual-link A.B.C.D dead-
interval
<1-65535>
area <0-4294967295> virtual-link A.B.C.D
transmit-delay <1-65535>
Router Configures a virtual link.
The following example shows how to configure virtual link with more than 2 options:
• area <0-4294967295> virtual-link A.B.C.D authentication-key KEY authentication
[message-digest | null]
• area <0-4294967295> virtual-link A.B.C.D hello-interval <1-65,535> dead-interval
<1-65535>
To Next Page
Loading...
