● Metric
Shows the metric of the route. The higher value, the longer packets require to their
destination.
● Routing Protocol
Shows the routing protocol from which the entry in the routing table originates. The following
entries are possible:
– Connected: Connected routes
– Static: Static routes
– RIPng: Routes via RIPng
– OSPFv3: Routes via OSPFv3
– Other: Other routes
6.4.13 DHCP-Server
This page shows which IPv4 addresses were assigned to the devices by the DHCP server.
Description
● IP Address
Shows the IPv4 address assigned to the DHCP client.
● Pool ID
Shows the number of the IPv4 address band.
● Identification Method
Shows the method according to which the DHCP client is identified.
● Identification value
Shows the MAC address or the client ID of the DHCP client.
● Allocation Method
Shows whether the IPv4 address was assigned statically or dynamically. You configure the
static entries in "System > DHCP > Static Leases".
Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 111
To Next Page
Loading...
Need help?
General
