The table has the following columns:
● Radio
Specifies the WLAN interface to which the settings relate.
● Port
Specifies the VAP interface to which the settings relate.
● SSID
Specifies the SSID to which the settings relate.
● Enable
When enabled, the access restriction is used. You configure which devices are accessible
to the clients in "Security > Inter AP Blocking > Allowed Addresses".
● Block Gratuitous ARP Requests
When enabled, gratuitous ARP packets from this VAP interface are not forwarded to
Ethernet.
● Block Non-IP Frames
When enabled, there is no exchange of non-IP packets, for example layer 2 packets
between the client and the devices configured on the access point as permitted
communications partners.
6.10.6.2 Allowed Addresses
Note
This WBM page is only available in access point mode.
On this WBM page, you specify which devices are accessible to the clients.
Configuring with Web Based Management
6.10 "Security" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 327
To Next Page
Loading...
Need help?
General
