If you require additional authentication methods, you can configure them after completing the
Basic Wizard with "Security > WLAN > Client Radius Supplicant".
Note
This page is only available for clients or access points in client mode.
Description
Table 1 contains the following columns:
● Security Context
Shows Security Context 1.
● Dot1x User Name
Enter the user name with which the client will log on with the RADIUS server.
● Dot1x User Password
Enter the password for the user name selected above. The client is logged on with the
RADIUS server using this combination.
For password assignment, ASCII code 0x20 to 0x7e is used.
● Dot1x User Password Confirmation
Enter the password again in this input box.
6.3.1.12 Dot1x RADIUS Server Settings
Introduction
On this Basic Wizard page, you configure the settings for the primary RADIUS Server.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 81
To Next Page
Loading...
Need help?
General
