6.3.1.2 Country Settings
Introduction
On this Basic Wizard page, you configure the country and the system name.
Description
The Basic Wizard page contains the following boxes
● Country Code
From this drop-down list, select the country in which the device will be deployed. You do not
need to know the data for the specific country, the channel division and output power are set
by the device according to the country you select.
Note
Locale setting
The correct country setting is mandatory for operation complying with the approvals.
Selecting a country different from the country of use can lead to legal prosecution.
● System Name
You can enter the name of the device. If you configure this box, this configuration is adopted
and displayed in the selection area. A maximum of 255 characters are possible.
The system name is also displayed in the CLI input prompt. The number of characters in the
CLI input prompt is limited. The system name is truncated after 16 characters.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
64 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
