6.3.1.3 IP Address Settings
Introduction
One of the basic steps in configuration of a device is setting the IP address. The IP address
identifies a device in the network uniquely.
Description
The Basic Wizard page contains the following boxes:
● DHCP Client
Specify how the IP address will be assigned. There are two methods of assigning IP
addresses.
– Enabled
The device obtains a dynamic IP address from a DHCP server.
– Disabled
You enter the IP settings in the input boxes "IP Address" and "Subnet Mask".
● IP Address
Enter an IP address that is unique within your network.
● Subnet Mask
Enter the subnet mask of the device.
● Default gateway
Enter the IP address of the default gateway so that the device can communicate with
devices in other subnets, for example diagnostics stations, e-mail server.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 65
To Next Page
Loading...
