6.3 "Wizard" menu
6.3.1 Basic Wizard
Introduction
With the Basic Wizard, menus guide you through the configuration of the most important
parameters.
On the Basic Wizard pages, you can only configure the parameters important for the basic
functionality. You make further settings when you have finished with the Basic Wizard.
Requirement
● The device is in the status it was when it was shipped and can be reached via the Ethernet
interface.
● You have assigned an IP address to the device. For more detailed information, refer to the
section "IP addresses (Page 47)".
● You are logged in to the WBM as a user with administrator rights. For more detailed
information, refer to the section "Login (Page 59)".
Starting the Basic Wizard
Click on "Wizard > Basic Wizard" in the navigation area to start the Basic Wizard.
When you log in for the first time or following a "Restore Factory Defaults", the Basic wizard is
started automatically after you have changed the default password.
Buttons you require often
The WBM pages of the Basic Wizard contain the following buttons:
Button Description
Goes to the next page
Goes back to the previous page
The Basic Wizard is closed without adopting the settings.
Saves the configuration and exits the Wizard.
Navigation within the pages of the Basic Wizard is possible only with the "Previous" and "Next"
buttons.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 61
To Next Page
Loading...
Need help?
General
