After completing the Basic Wizard, you can configure a backup server and other settings, for
example the number of logon attempts with "Security> WLAN > AP Radius Authenticator.
Note
This page is available only in access point mode.
Description
This table contains the following columns:
● Server Role
Shows the role of the server.
● Server IP Address
Enter the IP address of the RADIUS server. The use of the computer name (name resolution
using DNS) instead of the IP address is not supported.
● Server Port
Enter the port of the RADIUS server.
● Shared Secret
Enter the password of the RADIUS server.
● Shared Secret Conf
Enter the password again in this input box.
6.3.1.13 Summary of Settings
Introduction
The settings are summarized on this page. The content of the page depends on the set
parameters and the mode of the device.
Check the settings before you exit the Basic Wizard with the "Set Values" button. If settings are
incorrect, go back using the "Prev" button and change the settings to the required ones.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
82 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
