6.3.1.4 Management Interfaces
System configuration
On this Basic Wizard page, you specify the services with which the device can be accessed.
With some services, there are further configuration pages on which more detailed settings can
be made. Configure these services after completing the Basic Wizard.
Description
The page contains the following boxes:
● Telnet Server
Enable or disable the "Telnet Server" service for unencrypted access to the CLI.
● SSH Server
Enable or disable the "SSH Server" service for encrypted access to the CLI.
● DCP Server
Specify whether or not the device can be accessed with DCP (Discovery and Configuration
Protocol):
– "-" (disabled)
DCP is disabled. Device parameters can neither be read nor modified.
– Read/Write
With DCP, device parameters can be both read and modified.
– Read-Only
With DCP, device parameters can be read but cannot be modified.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
66 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
