Description
The page contains the following boxes:
● No. of Signaled Faults
Indicates how often the fault LED lit up and not how many faults occurred.
● "Reset Counters" button
The number is reset with this button. The counter is reset when there is a restart.
The table contains the following columns:
● Fault Time
Shows the time the device has been running since the last restart when the described fault
occurred.
● Fault Description
Displays a brief description of the error/fault that has occurred.
● Clear Fault State
Some faults can be acknowledged and thus removed from the fault list, e.g. a fault of the
event "Cold/Warm Start". You can acknowledge these faults or remove them from the fault
list with the "Clear Fault State" button.
6.4.7 Redundancy
Introduction
The page shows the current information about the Spanning Tree and the settings of the root
bridge.
If Spanning Tree is turned off, only the basic information about this device is displayed.
Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 99
To Next Page
Loading...
Need help?
General
