Siemens SCALANCE W1780 - Menu Layer 3 (Ipv6); Subnets

Procedure
1. Enter the network address of the destination in the "Destination Network" input box.
2. Enter the corresponding subnet mask in the "Subnet Mask" input box.
3. For "Interface", select the entry "auto".
4. Enter the gateway in the "Gateway" input box.
5. Enter the weighting of the route in "Administrative Distance".
6. Click the "Create" button. A new entry is generated in the table.
7. Click the "Set Values" button.
6.9 Menu "Layer 3 (IPv6)"
6.9.1 Subnets
Configuration of the IP addresses
On this page, you enable IPv6 at the VLAN interface. This VLAN interface is also called an IPv6
interface. An IPv6 interface can have several IPv6 addresses.
Configuring with Web Based Management
6.9 Menu "Layer 3 (IPv6)"
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 289