7. Enable the SMTP server entry.
8. Click the "Set Values" button.
Note
Depending on the properties and configuration of the SMTP server, it may be necessary to
adapt the "Sender E-Mail Address" input for the e-mails. Check with the administrator of the
SMTP server.
Testing the configuration of the SMTP server
1. Configure recipients
– Click the "Recipient" tab.
– Select the desired SMTP server under "SMTP server".
– Enter the desired address under "E-mail address of the SMTP recipient".
– Click the "Create" button. A new entry is generated in the table. The setting "Send" is
activated by default.
2. Send test e-mail
– Click the "General" tab.
– Click the "Test" button next to the SMTP server entry. The device sends to every
configured recipient
– Check the test result. If sending was not successful, the message contains possible
causes.
6.5.9.2 Recipient
On this page, you specify who receives an e-mail when an event occurs.
Configuring with Web Based Management
6.5 "System" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
172 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
