Description
The Basic Wizard page contains the following boxes:
● Restore Memory Defaults and Restart
If you click this button, the factory configuration settings are restored with the exception of
the parameters below followed by a restart.
– IP address
– Subnet mask
– IP address of the default gateway.
– DHCP client ID
– DHCP
– System name
– System location
– System contact
– User names and passwords
– Mode of the device
After restarting the device, you will need to log in again and start the Basic wizard again to
configure the device.
● Device Mode
Select the mode of the device. This selection is available only for access points.
The following operating modes are possible:
– AP: Access point mode
– Client: Client mode
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 63
To Next Page
Loading...
