● Web Server
You configure the setting in "System > Configuration".
– HTTP/HTTPS: Access to the WBM is possible with HTTP and HTTPS.
– HTTPS: Access to the WBM is now only possible with HTTPS.
● SNMP
You can configure the setting in "System > SNMP > General".
– "-" (SNMP disabled)
Access to device parameters via SNMP is not possible.
– SNMPv1/v2c/v3
Access to device parameters is possible with SNMP versions 1, 2c or 3.
– SNMPv3
Access to device parameters is possible only with SNMP version 3.
● Management ACL
You configure the setting in "Security > Management ACL".
– Disabled: no access restriction
The access control is disabled.
– Enabled: no access restriction
The access control is enabled but no access rules have been defined.
– Enabled: restricted access only
The access control is enabled and access rules have been defined.
● Login Authentication
You configure the setting in "Security > AAA > General".
– Local
Login with local user name and password.
– RADIUS
Login using a RADIUS server.
– Local and RADIUS
The login is possible both with the users that exist in the firmware (user name and
password) and via a RADIUS server. The local users have priority.
Note
The user is first searched for in the local database. If the user does not exist there or the
password does not match, a RADIUS query is sent.
● Password Policy
Shows which password policy is currently being used.
Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
114 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
