Siemens SCALANCE W1780 User Manual

Description
Table 1 has the following columns:
● Radio
Shows the available WLAN interfaces.
● WLAN Mode
Shows the transmission standard. If DFS is activated, the transmission standard "802.11h"
is not shown additionally but only the configured transmission standard with the suffix
"DFS".
● Configured Channel
Shows the configured channel. If "Auto" is displayed, the access point searches for a free
channel itself.
● Alternative DFS Channel
If the DFS function is enabled, the configured alternative channel of the access point is
displayed.
If "Auto" is displayed, the access point searches for an alternative channel itself.
If the DFS function is activated and the access point searches for competing radar signals
for 60 seconds before starting communication with the selected channel, the text
"scanning ..." is displayed instead of the channel.
● Operational channel
Shows the channel including the frequency via which the access point communicates.
At 80 MHz the channel range is displayed additionally.
● Channel Width [MHz]
Shows the set channel bandwidth.
– 20 MHz
– 40 MHz (only with IEEE 802.11n/ac)
– 80 MHz or 160 MHz (only with IEEE 802.11ac)
● iFeatures
Shows which iFeatures are used.
– - iFeatures are not used.
– iPRP
● State
Shows the status of the WLAN interface.
– enabled
The WLAN interface is enabled.
– disabled
The WLAN interface is disabled.
Table 2 has the following columns:
● Radio
Shows the available WLAN interfaces in this column.
● Port
Shows the port of the virtual access point (VAP).
Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03 119

Siemens SCALANCE W1780 Specifications

General

Brand	Siemens
Model	SCALANCE W1780
Category	Wireless Access Point
Language	English