Description
The table has the following columns:
● Port
Shows the available VAP interfaces.
● Destination Address / State
Shows which destination address is monitored and the status of the connection. You
configure the destination address in "Interfaces > WLAN > Force Roaming".
– Not configured: No destination address is configured.
– Idle: The destination address was not found.
– Up: The destination address is reachable.
– Down: The destination address is not reachable.
● IP address not reachable - Force roaming
Indicates whether roaming is currently being performed.
– Inactive: The client is not forced to perform roaming. The corresponding VAP interface
is not deactivated.
– Active: None of the destination addresses is reachable. To force the logged on clients to
roam, the access point has disabled the relevant VAP interface.
Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
130 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
