Description
The page contains the following boxes:
● Pool ID
From the drop-down list, select the required IPv4 address band.
● Hardware Type
Select the method according to which a client is identified.
– Ethernet MAC
The client is identified by its MAC address.
– Client ID
The client is identified by a freely defined DHCP client ID. The client ID can be up to a
maximum of 254 characters long.
● Value
Enter the MAC address or the client ID and click the "Create" button to create the entry.
Note
A maximum of 20 entries are possible.
The table has the following columns:
● Select
Select the check box in the row to be deleted.
● Pool ID
● Shows the number of the IPv4 address band.
Note
Only Pool ID = 1 is supported.
● Identification Method
Shows whether the client is identified by its MAC address or the client ID.
● Value
Shows the MAC address to which the IPv4 address is assigned.
● IP Address
Specify the IPv4 address. The IPv4 address must match the subnet of the IPv4 address
band.
Configuring with Web Based Management
6.5 "System" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
180 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
