● within own VAP
– Enabled
Clients logged on to the same VAP interface of an access point can communicate with
each other.
– Disabled
Option is disabled.
● with other VAPs
– Enabled
Clients logged on to different VAP interfaces of an access point can communicate with
each other.
Note
For an access point, "with other VAPs" needs to be enabled on all WLAN interfaces or
on all VAP interfaces to allow communication between clients logged on at different VAP
interfaces of the access point.
– Disabled
Option is disabled.
Note
"within own VAP" or "with other VAPs" function disabled
If the "within own VAP" or "with other VAPs" function is disabled the various WLAN clients
can no longer see each other. This means that Address Collision Detection (ACD) also no
longer works reliably.
● with Ethernet
– Enabled
Clients can communicate via the Ethernet interface of the access point.
– Disabled
Option is disabled.
● Client Limiter
– Enabled
The number of WLAN clients that can be logged on simultaneously is limited.
– Disabled
Option is disabled.
● Max. Clients
Set the maximum number of clients that can connect to this interface at the same time. If the
number is exceeded, additional clients are rejected.
Configuring with Web Based Management
6.10 "Security" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
316 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
