Siemens SCALANCE W1780 - Page 318

● Shared Secret
Enter the password of the RADIUS server.
For the password, ASCII code 0x20 to 0x7e is used.
● Shared Secret Conf
Confirm the password.
● Max. Retransmissions
Enter the maximum number of connection attempts.
● Primary Server
Specify whether or not this server is the primary server.
– Yes: Primary server
– No: Backup server.
● State
With this check box, you can enable or disable the RADIUS server
Procedure
Entering a new server
To display a new server, follow the steps below:
1. In the relevant row, enter the following data in the input boxes:
– IP address or FQDN of the RADIUS server
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
Modifying servers
1. In the relevant row, enter the following data in the input boxes:
– IP address or FQDN of the RADIUS server
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
Repeat this procedure for every server whose entry you want to modify.
Configuring with Web Based Management
6.10 "Security" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
318 Configuration Manual, 11/2019, C79000-G8976-C485-03