Alarm Description
VAP<number> Client <MAC> failed to authenticate; status
(<status>)
The authentication of the client failed. The reason is displayed
as text.
VAP<Num>: Client <MAC> failed to disassociated; status
(<text>)
The connection of the client could not be terminated. The reason
is displayed as text.
VAP<Num>: Client <MAC> associated successfully The client has connected successfully to the VAP or the client
has logged on successfully to the VAP.
RADIUS: Access rejected for client <MAC> The RADIUS server denies the client access.
RADIUS: Access accepted for client <MAC> The RADIUS server allows the client access.
WDS Connection is established to AP <MAC> The WDS connection is successfully established to the access
point.
WDS disconnect from AP <MAC> The WDS connection to the access point is terminated.
Messages in client mode
Alarm Description
Associated successfully to AP <MAC address> <system
name> at channel <channel number> (frequency <frequen‐
cy> MHz)
The client has logged in successfully on the access point.
Disassociated from AP <MAC address> <'sys name'> with
reason (Disassociated because sending STA is leaving (or
has left) BSS)
The client was logged off from the access point.
Failed to authenticate to AP <MAC>; status (<Text>) The authentication of the client with the access point failed. The
reason is displayed as text.
Failed to disassociate from AP <MAC>; status (<Text>) The connection of the client to the access point could not be
terminated. The reason is displayed as text.
Failed to associate to AP <MAC>; status (<Text>) The connection of the client to the access point has failed. The
reason is displayed as text.
Appendix D
D.2 Messages in the WLAN Authentication Log
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
354 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
