Description
Table 1 contains the following columns:
● Radio
Shows the available WLAN interfaces.
● Use Allowed Channels only
If you enable the option, you restrict the selection of channels via which the client is allowed
to establish the connection.
In the following tables, you define the channels on which the client searches for an AP.
The tables are divided up according to frequency bands.
If the option is disabled, the channels available based on the settings (country code,
antennas, transmit power etc.) are used.
Above the tables for the frequency bands, you will find the following check box:
● Select / Deselect all
– Enabled
If you enable the check box, all channels are selected.
– Disabled
If you deselect the check box, only the first valid channel of the frequency band remains
enabled.
Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
76 Configuration Manual, 11/2019, C79000-G8976-C485-03
To Next Page
Loading...
Need help?
General
