Siemens SIDOOR ATD4 W Series - Controllers; Description of Controller; Installing the Control Unit

Controllers
5
5.1 Description of controller
Overview
SIDOOR ATD4xxW
INTERFACE MODULE
(OPTIONAL)
INPUT 0



① Connecting terminals
② Relay module / PROFIBUS module / PROFINET module
③ Service buttons/Minimal editor
④ Terminal module
5.2 Installing the control unit
Requirement
The installation site must ful󹪝ll the following requirements:
• Minimum clearance to surrounding parts 1 cm
• Even mounting surface
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA 127