Siemens SIDOOR ATD4 W Series - Target Group

Information regarding third-party products
Note
Recommendation relating to third-party products
This document contains recommendations relating to third-party products. Siemens accepts the
fundamental suitability of these third-party products.
You can use equivalent products from other manufacturers.
Siemens does not accept any warranty for the properties of third-party products.
1.2.2 Target group
The system manual is intended for:
• Assemblers
• Commissioning engineers
• Operators
• Service personnel
• Project engineers of machine protection doors
Revision of the system
manual
Change
06/2016 First edition
01/2017 Revision of MDG700 NMS
06/2018 Changes according to 󹪝rmware update V1.12
Note:
Read the instructions in the following sections before updating to V1.12:
• Deactivation of the service buttons during emergency stop (as of V1.12)
(Page 116)
11/2018 Change for motors
09/2020 Integration of changes from document "Release Notes Firmware ATD4xxW
V1.13".
Changes according to 󹪝rmware update V1.14.
Note:
After the update to V1.14 all parameters are set to default values. User-spe‐
ci󹪝c settings have to be set again.
Introduction
1.2 About this manual
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA 13