Technical specifications
12
12.1 General technical specifications
What are general technical specifications?
The technical specifications contain:
● The standards and test values that observe and fulfil the described components.
● The test criteria used to test the described components.
12.1.1 Standards and approvals for SIMATIC Compact Field Unit PA (CFU PA)
Validity of the information on the device
Note
Markings and approvals
In the manual you can find the markings and approvals which are generally possible or planned
in the system.
The identification or approval that is printed on the device continues to be exclusively valid!
The currently valid markings and approvals are printed on the component.
Information on certificates can be found in the product information.
The product information is made available with the product or on the Internet by specifying the
article number: Service & Support (http://support.automation.siemens.com/WW/view/
109748348).
12.1.1.1 CE conformity
Introduction
The CFU fulfils the requirements and protective aims of the following EU directives and
conforms with the harmonized European standards (EN) that have been published for
programmable logic controllers in the Official Journals of the European Union:
● Low-Voltage Directive
● EMC Directive
SIMATIC CFU
Commissioning Manual, 08/2019, A5E39252870-AD 147
To Next Page
Loading...
Need help?
General
