Installation instructions according to cFMus
WARNING
Installation instructions according to cFMus
WARNING – Explosion Hazard - Do not connect or disconnect the device while circuit is live
unless area is known to be non-hazardous.
WARNING – Explosion Hazard - Substitution of components can impair suitability for Class I,
Division 2 or Class I, Zone 2.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C or D; Class I, Zone 2,
Group IIC, or non-hazardous locations only.
12.1.1.7 Tick mark for Australia and New Zealand
The components described satisfy the requirements of the following standard:
EN 61000-6-4: 2007 + A1: 2011
12.1.1.8 Standards for communication connections
The components described satisfy the requirements of the following standards:
● IEC 61158
● IEC 61784
– The following applies for communication with the automation system over PROFINET:
Compliance to IEC 61784 Ed.2:2007 CPF 3/5
– The following applies for communication with field devices over PROFIBUS PA:
Compliance to IEC 61784 Ed.2:2007 CPF 3/2
12.1.1.9 Safety regulations and special requirements
The components described satisfy the requirements and criteria of the following standard:
IEC 61010-2-201:2017 (Second Edition) / EN 61010-2-201:2017
(Note: These standards were supplemented by IEC 61010-1:2010 (Third Edition) / EN
61010-1:2010)
12.1.2 Standards and approvals for SIMATIC Compact Field Unit DIQ (CFU DIQ)
This chapter contains the following for the device:
● The standards and test values that the device complies with and fulfills.
● The test criteria according to which the device was tested.
Technical specifications
12.1 General technical specifications
SIMATIC CFU
152 Commissioning Manual, 08/2019, A5E39252870-AD
To Next Page
Loading...
Need help?
General
