Assigning the CFU parameters without a project
1. Select the menu command "PLC > Edit Ethernet Node".
2. Click the "Browse" button in the "Ethernet node" area.
3. Select the CFU.
Set the following in the dialog:
– IP configuration of the CFU (Set IP configuration" area)
– Device name ("Device name" area)
You can find additional information in the STEP 7 online help.
Commissioning
8.6 Preparing the CFU for commissioning
SIMATIC CFU
Commissioning Manual, 08/2019, A5E39252870-AD 81
To Next Page
Loading...
