Siemens SINAMICS G110M - Generating a STARTER Project

Commissioning
5.2 Basic commissioning
SINAMICS G110M Operating Instructions
108 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
5. Acknowledge this message, and set the "Access point" to "DEVICE (STARTER, Scout)"
and the "PG/PC interface" to "S7USB".
6. Then click on "Update". The connected converters are now displayed in "Accessible
nodes".
7. Close this screen form without selecting the converter(s) that has/have been found.
8. Create your STARTER project (Page 108).
You have set the USB interface.
5.2.7.2
Generating a STARTER project
Creating a STARTER project using project wizards
Procedure
To create a project with the STARTER project Wizards, proceed as follows:
1.
Using "Project / New with
wizard" create a new project.
2.
To start the wizard, click on
"Search online for drive
units ...".
3.
Follow the instructions of the
Wizard, and set everything that
you require for your particular
project.