Siemens SINAMICS G110M - Speed Limitation

Functions
8.5 Setpoint calculation
SINAMICS G110M Operating Instructions
178 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Minimum speed
The converter prevents continuous motor operation at speeds < minimum speed.
Speeds where the absolute value is less than the minimum speed are only possible during
motor operation when accelerating or braking.
Table 8- 8 Setting the minimum speed
Parameter
Description
p1080
Minimum speed (factory setting: 0 rpm)
p1106 CI: Minimum speed signal source (factory setting: 0)
Dynamic specification of the minimum speed
8.5.5
Speed limitation
The maximum speed limits the speed setpoint range for both directions of rotation.
The converter generates a message (fault or alarm) when the maximum speed is exceeded.