Siemens SINAMICS G110M - Appendix; New and Extended Functions

SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
311
Appendix
A
A.1
New and extended functions
Table A- 1 New functions and function changes in Firmware 4.7 SP3
Function
SINAMICS
G120
G120D
1 PM240-2 Power Modules, frame sizes FSD and FSE are sup-
ported
- - ✓ ✓ ✓ ✓ - - -
The Safety Integrated basic function Safe Torque Off (STO) is
supported via the terminals of the PM240-2 Power Module,
frame sizes FSD and FSE
- - - - ✓ ✓ - - -
2 Revised PM230 Power Module with new Article numbers sup-
ported:
• IP55 degree of protection: 6SL3223-0DE . . - . .
G
.
• IP20 degree of protection and Push Through: 6SL321 . -
1NE . . - . .
G
.
- - ✓ ✓ ✓ - - - -
The Safety Integrated basic function Safe Torque Off (STO) is
supported with the revised PM230 Power Module
- - - - ✓ - - - -
3
PM330 Power Module, frame size HX is supported
-
-
✓
-
-
-
-
-
-
4
1FP1 reluctance motors are supported
-
-
✓
-
-
-
-
-
-
5
Encoderless 1FK7 synchronous motors are supported
-
✓
-
✓
✓
✓
✓
1)
-
-
6
Encoderless 1FG1 geared synchronous motors are supported
-
✓
-
✓
✓
✓
✓
-
-
7 SINAMICS “Standard Drive Control” and “Dynamic Drive Con-
trol” application classes to simplify commissioning and increase
the degree of ruggedness of the closed-loop motor control.
The SINAMICS application classes are available with the fol-
lowing inverters:
• SINAMICS G120C
• SINAMICS G120 with PM240, PM240-2 and PM330 Power
Modules
- ✓ ✓ ✓ ✓ ✓ - - -
8 Moment of inertia estimator with moment of inertia precontrol to
optimize the speed controller in operation
✓ ✓ - ✓ ✓ ✓ ✓ ✓ ✓
9 Friction torque characteristic with automatic plotting to optimize
the speed controller
✓ ✓ - ✓ ✓ ✓ ✓ ✓ ✓
10
Automatic optimization of the technology controller
-
-
✓
✓
✓
-
-
-
-