Siemens SINAMICS G110M - List of Alarms and Faults

Alarms, faults and system messages
11.5 List of alarms and faults
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
297
Designation
Format
Example for the
content
Valid for
PROFINET
Valid for
PROFIBUS
ORDER_ID Visible String
[20]
„6SL3246-0BA22-
1FA0“
✓ ✓
SERIAL_NUMBER Visible String
[16]
„T-R32015957“ ✓ ✓
HARDWARE_REVISION
u16
0001 hex
✓
✓
SOFTWARE_REVISION
char, u8[3]
„V“ 04.70.19
✓
✓
REVISION_COUNTER
u16
0000 hex
✓
✓
PROFILE_ID
u16
3A00 hex
✓
✓
PROFILE_SPECIFIC_TYPE
u16
0000 hex
✓
✓
IM_VERSION
u8[2]
01.02
✓
✓
IM_SUPPORTED
bit[16]
001E hex
✓
✓
11.5
List of alarms and faults
Axxxxx Alarm
Fyyyyy: Fault
Table 11- 6 Faults, which can only be acknowledged by switching the inverter off and on again
Number
Cause
Remedy
F01000
Software fault in CU
Replace CU.
F01001
Floating Point Exception
Switch CU off and on again.
F01015
Software fault in CU
Upgrade firmware or contact technical support.
F01018 Power-up aborted more than once After this fault is output, the inverter powers up with the factory settings.
Remedy: Back up factory setting with p0971=1. Switch CU off and on
again. Recommission the inverter.
F01040 Parameters must be saved Save parameters (p0971).
Switch CU off and on again.
F01044 Loading of memory data card de-
fective
Replace memory card or CU.
F01105
CU: Insufficient memory
Reduce number of data records.
F01205 CU: Time slice overflow Contact technical support.
F01250
CU hardware fault
Replace CU.
F01512 An attempt has been made to
establish an conversion factor for
scaling which is not present
Create scaling or check transfer value.
F01662 CU hardware fault Switch CU off and on again, upgrade firmware, or contact technical sup-
port.
F30022
Power Module: Monitoring U
CE
Check or replace the Power Module.
F30052
Incorrect Power Module data
Replace Power Module or upgrade CU firmware.
F30053
Error in FPGA data
Replace the Power Module.
F30662 CU hardware fault Switch CU off and on again, upgrade firmware, or contact technical sup-
port.