Siemens SINAMICS G110M - Mistakes and Improvements

Appendix
A.10 Mistakes and improvements
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
333
EMC Immunity
The SINAMICS G110M drives have been tested in accordance with the immunity
requirements of category C3 (industrial) environment:
Table A- 18 EMC Immunity
EMC Phenomenon
Standard
Level
Performance
Criterion
Electrostatic Discharge (ESD) EN 61000-4-2
4 kV Contact discharge
A
8 kV Air discharge
Radio-frequency Electromagnet-
ic Field
EN 61000-4-3 80 MHz … 1000 MHz
10 V/m
A
Amplitude modulated 80 % AM @ 1 kHz
Fast Transient Bursts
EN 61000-4-4
2 kV @ 5 kHz
A
Surge Voltage
EN 61000-4-5
1 kV differential (L-L)
A
1.2/50 μs
2 kV common (L-E)
Conducted EN 61000-4-6 0.15 MHz … 80 MHz
10 V/rms
A
Radio-frequency Common Mode
80 % AM @ 1 kHz
Mains Interruptions & Voltage
Dips
EN 61000-4-11
95 % dip for 3 ms
A
30 % dip for 10 ms
C
60 % dip for 100 ms
C
95 % dip for 5000 ms
D
Voltage Distortion
EN 61000-2-4
10 % THD
A
Voltage Unbalance EN 61000-2-4 3 % Negative Phase Se-
quence
A
Frequency Variation EN 61000-2-4 Nominal 50 Hz or 60 Hz
(± 4 %)
A
Commutation Notches EN 60146-1-1
Depth = 40 %
A
Area = 250 % x degrees
A.10
Mistakes and improvements
If you come across any mistakes when reading this manual or if you have any suggestions
for how it can be improved, then please send your suggestions to the following address or by
E-mail:
Siemens AG
Digital Factory
Motion Control
Postfach 3180
91050 Erlangen, Germany
E-mail (mailto:docu.motioncontrol@siemens.com)