Siemens SINAMICS G110M - 5 Commissioning; Commissioning Guidelines

SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
83
Commissioning
5
5.1
Commissioning guidelines
We recommend the following procedure:
1.
Define the requirements of
your application placed on
the drive.
→ (Page 84) .
2.
Reset the converter when
required to the factory
setting.
→ (Page 92) .
3.
Check whether the factory
setting of the converter is
appropriate for your
application.
If not, start with the basic
commissioning.
→ (Page 84) .
→ (Page 95) .
4.
Check whether you need to
adapt the commissioning
DIP switches.
→ (Page 125).
5.
If necessary, adapt the
communications interface in
the converter.
→ (Page 117) .
6.
If necessary, set further
functions in the converter.
→ (Page 161) .
7.
Save your settings.
→ (Page 261) .
You have fully commissioned the converter.