Siemens SINAMICS G110M - Performance Ratings Power Module

Technical data
12.2 Performance ratings Power Module
SINAMICS G110M Operating Instructions
304 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
12.2
Performance ratings Power Module
SINAMICS PM240M performance ratings
Table 12- 2 Power Module performance ratings
Feature
Specification
Line operating voltage &
power ranges
3 AC 380 V (- 10%) … 480 V (+ 10%)
High Overload: 0.37 kW … 4.0 kW (0.5 hp … 5.0 hp)
Input frequency
47 Hz … 63 Hz
Output frequency
0 Hz … 650 Hz
cos φ
0.95
Inverter efficiency
95% … 97%
Overload capability (HO)
2 x Nominal output current for 3 seconds followed by 1.5 x Nominal output
current for 57 seconds every 300 seconds (averages as 110%).
For 4 kW variant:
1.6 x Nominal output current for 3 seconds followed by 1.5 x Nominal
output current for 57 seconds every 300 seconds (averages as 110%).
Inrush current
Less than rated input current
Pulse frequency
4 kHz (standard); 4 kHz … 16 kHz (in 2 kHz steps)
Electromagnetic compat-
ibility
Internal Class A filters according to EN 55011
Protection level
IP65/IP66 (when Power Module and Control Unit is fully assembled).
Temperature range
CU: -10 °C … +55 °C (14 °F … 131 °F) - High Overload (HO)
Storage temperature
-40 °C … +70 °C (-40 °F … 158 °F)
Humidity
< 95% RH - non-condensing
Operational altitude
Up to 1000 m (3280 ft) above sea level without derating
Protection features Undervoltage, Overvoltage, Overload, Ground faults, Short circuit, Stall
prevention, Motor blocking protection, Motor overtemperature, Power
Module overtemperature, Parameter interlock
Standards UL, cUL, CE, C-tick
CE mark Conformity with EC Low Voltage Directive 73/23/EEC and filtered ver-
sions also Electromagnetic Compatibility Directive 89/336/EEC
EM Brake
180 V DC (400 V half-wave rectified) 1A maximum